Emilia Davidson

uPASS Reach Wiegand Test

1. uPASS
2. Documentation

Step 1. Create a short jumper wire 2-3 inches.Step 2. Turn dipswitch 3 “OFF” on SW-3 (image 1). This will put the reader into test mode and the LED’s on the UHF Processor (silver processor directl...

• Edited June 30, 2023 09:42
• 1 follower
• 0 comments
• 0 votes

Wiegand format and Protocol for the Transit Ultimate

1. TRANSIT
2. Documentation

  The Wiegand protocol is set at the reader level through the 1st three dipswitches on the bank of eight, on the mainboard. Out of the box, the reader is set to output Wiegand 26 with the Facility...

• Edited June 30, 2023 09:40
• 1 follower
• 0 comments
• 0 votes

OSDP and Transit Ultimate Wiring and Output

1. TRANSIT
2. Documentation

To have the Transit Output the OSDP Protocol you will need to purchase and install an additional OSDP board. 9229078 OSDP Installation Board (includes PCC485)   9565817 PCC485 OSDP Protocol Conve...

• Edited June 30, 2023 09:50
• 1 follower
• 0 comments
• 0 votes

uPASS Reach and OSDP

1. uPASS
2. Documentation

The Process of switching from Standard to OSDP Communication is done with a USB type A to Type B connection and the UHFTool. The firmware of the uPASS Reach (UHF processor) can be updated using UH...

• Edited June 30, 2023 09:52
• 1 follower
• 0 comments
• 0 votes

uPASS Access and OSDP

1. uPASS
2. Documentation

The Process of switching from Standard to OSDP Communication is done with a USB type A to Type B connection and the UHFTool.   The firmware of the uPASS Reach (UHF processor) can be updated using ...

• Edited June 30, 2023 09:55
• 1 follower
• 0 comments
• 0 votes