Emilia Davidson
Activity overview
Latest activity by Emilia Davidson-
Emilia Davidson created an article, uPASS Reach Wiegand Test
Step 1. Create a short jumper wire 2-3 inches.Step 2. Turn dipswitch 3 “OFF” on SW-3 (image 1). This will put the reader into test mode and the LED’s on the UHF Processor (silver processor directl...
-
Emilia Davidson created an article, Wiegand format and Protocol for the Transit Ultimate
The Wiegand protocol is set at the reader level through the 1st three dipswitches on the bank of eight, on the mainboard. Out of the box, the reader is set to output Wiegand 26 with the Facility...
-
Emilia Davidson created an article, OSDP and Transit Ultimate Wiring and Output
To have the Transit Output the OSDP Protocol you will need to purchase and install an additional OSDP board. 9229078 OSDP Installation Board (includes PCC485) 9565817 PCC485 OSDP Protocol Conve...
-
Emilia Davidson created an article, uPASS Reach and OSDP
The Process of switching from Standard to OSDP Communication is done with a USB type A to Type B connection and the UHFTool. The firmware of the uPASS Reach (UHF processor) can be updated using UH...
-
Emilia Davidson created an article, uPASS Access and OSDP
The Process of switching from Standard to OSDP Communication is done with a USB type A to Type B connection and the UHFTool. The firmware of the uPASS Reach (UHF processor) can be updated using ...
-
Emilia Davidson created an article, uPASS Target and OSDP
The Process of switching from Standard to OSDP Communication is done with a USB type A connection and the UHFTool. The firmware of the uPASS Reach (UHF processor) can be updated using UHFTOOL. Th...
-
Emilia Davidson created an article, TRANSIT Ultimate Wiegand Test
If the reader is lighting up and continuity has been established, but nothing is being seen on the panel, it is time for a Wiegand Test. Step 1. Turn the reader to Test Mode and set the 1st 3 switc...
-
Emilia Davidson created an article, TRANSIT Ultimate Tag Installation
It is important that there are no obstacles between the reader and the tag. The tag must be in the line of sight and within the detection range for optimal performance. The indicated side is the mi...
-
Emilia Davidson created an article, uPASS Reach Wiegand Test
If the reader is lighting up and continuity has been established, but nothing is being seen on the panel, it is time for a Wiegand Test. Step 1. Create a short jumper wire of 2-3 inches. Step 2. Tu...
-
Emilia Davidson created an article, uPASS Reach Quick Install Guide
Power Supply Linear 24vdc 2-3 AMP Cabling Shielded twisted 6 (18-22 Gauge) for communication wiring.A separate twisted pair (14-18 Gauge) for the power supply. Tools 1 Phillips screwdriver to open...